Rover 200 & 400 Owners Club

Hi all,

I have a map sensor that I have just found for my t16 conversion. Trouble is where does it plug into and the vac pipe does it just go the the inlet mani on a empty nipple.


Also while I'm at it on my loom that cable guy did from rover tech I have a blue ovalish plug 2 wire, grey square plug 2 wire, black oval plug 3 wire.

The blue and grey go down the back behind the oil cooler I think it's just the black oval plug. Iirc when I got the loom it was linked into a turbo timer if that helps k owing what the plug does?.

Hope someone can help?

Thanks.

one nipple for vac iirc

That's the vac sorted for the map sensor just the plugs now then.

Also while I remember I have a nipple on the turbo inlet side does that go to a vac nipple too?
Same with the turbo actuator
And the separate dump valve
And I have a electronic boost controller.

Lots of confusing vac pipes.

This is my first conversion, so please bear with all the questions.

Thanks.